General Information; Function Check - conecto CC50686 Bedienungsanleitung

GENERAL INFORMATION

To ensure that you can enjoy this product for many years to come, please read this
manual and store it in a safe place. The m–FS300 house management system is capable
of switching connected electrical devices and lighting systems on and off with a remote
control up to a distance of 30 metres. The components (remote control and wireless socket)
communicate via a coded signal.
PREPARATION
Remove the plastic cover on the rear side of the remote control and insert the battery.
COMMISSIONING
1. Insert the wireless socket that is to be connected to your remote control into the socket.
2. After inserting the socket and while the red LED is flashing, press one of the ON buttons
on the left-hand side of the remote control, to connect the wireless socket with one of
the 4 channels on the remote control (A, B, C or D).
3. The wireless socket is now connected to the remote control. You can now insert the
device you wish to switch on and off into the connected wireless socket.

FUNCTION CHECK

1. You can check the functionality by pressing the ON button (left-hand side) of the remote
control for the previously selected letter (A, B, C or D). If you hear a "click" sound and
the LED illuminates constantly, the wireless socket is operational.
2. Then press the OFF button for the same letter on the right-hand side of the remote
control. You will hear another clearly audible "click" sound and the LED goes out. The
wireless socket is switched off.
- 2 -