Technical Data - Metz KH-BT03 Bedienungsanleitung

4 Comfort function
When switching off or if the connected devices are outside the max. range, the connection is
disconnected but the connection information is saved. When switching on again or when the
devices are within range again, the headphones automatically connect to the last connected
®
Bluetooth device. If this is not desired, it is necessary to temporarily deactivate the Blue-
®
tooth function on the last playback device used or to disconnect the saved connection with
"Metz KH-BT03" in the Bluetooth
connected to a device to a new device, switch off the headphones and start the Bluetooth
search (pairing) again.
Announcement / LED displays
A signal tone or an (announcement) sounds for the following events:
– Headphones have been switched on. (Power on / LED briefly lights up blue).
– Headphones were switched off. (Power off / Led briefly lights up red)
®
– Bluetooth search has been started. (Pairing / LED flashes blue-red )
®
– Bluetooth connection established. (LED flashes blue)
– Incoming call/ incoming call/ rejected call/ ended call.
– Skip to next track
– Low battery charge.

5 Technical data

Headphone:
– Frequency response: 20-20,000Hz
– Graphene Dynamic 40mm driver
– Sensitivity: 98±3dB (1KHz/1mW)
– Frequency range: 20Hz ... 20 KHz
– Max. volume: defined
– Impedance: 32 Ohm
– Bluetooth 5.0
– Weight: 245g
– Active Noise Cancellation (ANC)
– ANC depth: 28db
– Ambient noise function
®
Bluetooth with Qualcomm
– Version: V5.0
– Supported profiles: A2DP, AVRCP, HFP, HSP, aptX
– Range: up to 10m
– Frequency range : 2,402 GHz ... 2,480 GHz
– Transmission level: 2,5 mW (4 dBm)
®
settings. To connect headphones that are already
®
aptX™ HD:
TM
HD
14
®