MASCOT 205140 Bedienungsanleitung Seite 11

Charging method D
STEP 1 - BOOST CHARGE
LED-indicator: YELLOW
The charger is in constant current mode (CC), charging with the maximum current until
battery voltage reach Top-Up level.
STEP 2 – TOP-UP CHARGE
The charger is in constant voltage mode. The LED-indication will be FLASHING
YELLOW during Top-up charge. The charger stays in this mode until the charge current
decreases to charge termination level or the Top-Up Charge Timer runs out. The
battery is charged to its full capacity at the end of this step.
STEP 3 – FLOAT CHARGE
The LED-indication on the charger is GREEN and the battery is fully charged.
The charger is in standby mode. The charge voltage is at standby level and the
charger may remain connected to the battery.
The charger will return to boost charge if the battery is used.
BATTERY NOT CONNECTED INDICATIONS
Battery not connected is indicated by FLASHING GREEN
Diagram: D/ E
INDICATOR: YELLOW
Battery Voltage
Charge Current
Start Current
Low
Current Start-Up at Vbatt <10.5V
Error Mode if <10.5V after 30 minutes
(for 12V system)
Step 0
Start Timer
Boost Charge
(0.5 hours)
Safety Timer (72 hours)
Step 1
Top Up Charge (4 hours)
Lead acid diagrammer
INDICATOR:
FLASHING YELLOW
Charge Voltage
Cut-Off Current
Step 2
11
Yellow
Yellow
Green
INDICATOR: GREEN
Charge Voltage
Current pulses at safe float voltage level
for maximum topping of battery capacity.
Pulse frequency: Microprocessor controlled.
Pulse Current: max current
Step 3
Float Charge
EN