Battery Safety - StreamLight VANTAGE II Bedienungsanleitung

ENGLISH
Thank you for selecting the Vantage
reasonable care and maintenance of this product will provide years of dependable service.
Please read this manual before using your flashlight. It includes important safety and operating
instructions.
SAVE THESE INSTRUCTIONS. This guide contains important safety and operating instructions for
your Vantage II series flashlight.
®
LED SAFETY
LED RADIATION (RG-2). DO NOT STARE INTO BEAM. MAY BE HARMFUL TO
CAUTION
EYES. PER IEC 62471 ED 1.0:2006-07.

BATTERY SAFETY

EXPLOSION RISK, BURN, AND FIRE HAZARD. DO NOT DISASSEMBLE,
CAUTION
CRUSH, SHORT CIRCUIT, HEAT ABOVE 212°F (100°C), OR DISCARD IN
FIRE. DO NOT RECHARGE BATTERY. KEEP AWAY FROM CHILDREN. BATTERY MUST BE
RECYCLED OR DISPOSED OF PROPERLY.
USE ONLY: Streamlight, Panasonic or Sanyo size CR123A; Duracell 123A, or Energizer 123A.
MOUNTING: FIRE HELMET
1. Select the desired position above or below the helmet brim.
2. Loosen the clamp locking screw.
3. Slide the clamp assembly over the brim of
the helmet and rotate it to the desired position.
4. Tighten the locking screw until the Vantage
attached to the helmet using the hex key provided.
MOUNTING: INDUSTRIAL MOUNT
1. Insert locking tab into hard hat.
2. Push locating tab until assembly securely clicks.
3. To remove, depress tab and pull light from helmet.
MOUNTING: GALLET HELMET
1. Insert clamp in helmet slot until securely clicks
2. To remove, depress lock tab on helmet and slide rearwards.
II Series helmet-mounted LED flashlight. As with any fine tool,
®
II is securely
®
CLAMP
LOCKING
SCREW
LOCKING
TAB
GALLET
CLAMP