Built-In Automatic Protections; Automatic Defrost; Cleaning The Air Filter - Avalla S-80 Bedienungsanleitung

Built-in automatic protections

Automatic Defrost

When operating at low room temperatures, frost may build up on
the evaporator. If this happens, the Power LED will begin blinking
and the unit will automatically stop for a short time to carry out its
automatic defrosting procedure.
Overload Protection
In the event of sudden power loss, to protect the compressor there
is an automatic 3-minute delay until the compressor will restart.

Cleaning the air filter

Excess dust can cause airflow to become restricted which will
reduce efficiency and it can damage to the unit. The filter should be
cleaned regularly.
•
Ensure the unit is switched off and unplugged from the mains
power.
•
Remove the filter from the unit.
•
Use a vacuum cleaner to remove dust from the filter.
•
Rinse the filter under running water.
•
Allow the filter to air dry completely before reinstalling.
Warning: Do not touch the air inlet or the evaporator surface,
located behind the filter. Doing so could cause injury. Always
ensure the filter is completely dry before reinstalling into the unit.
Specifications
BTU
Circulation 290m3/h
Temp' range
Power
S-80 S-95
5000 7000
290m3/h
16-32ºC 16-32ºC
1460W 2050W
S-150 S-200
8000 9000
290m3/h 310m3/h
16-32ºC 16-32ºC
2345W 2600W
S-290
10000
310m3/h
16-32ºC
2930W
11