Herunterladen Inhalt Inhalt Diese Seite drucken

Rechargeable) Batteries; Power Adapter - VOLTCRAFT VC STK-3000 Bedienungsanleitung

Multifunktions-schleifenprozesskalibrator
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

e) (Rechargeable) batteries
• Correct polarity must be observed while inserting the (rechargeable) battery.
• The (rechargeable) batteries should be removed from the device if it is not used for a long period of time
to avoid damage through leaking. Leaking or damaged (rechargeable) batteries might cause acid burns
when in contact with skin, therefore use suitable protective gloves to handle corrupted (rechargeable)
batteries.
• (Rechargeable) batteries must be kept out of reach of children. Do not leave (rechargeable) batteries
lying around, as there is risk, that children or pets swallow them.
• All (rechargeable) batteries should be replaced at the same time. Mixing old and new (rechargeable)
batteries in the device can lead to (rechargeable) battery leakage and device damage.
• (Rechargeable) batteries must not be dismantled, short-circuited or thrown into fire. Never recharge
non-rechargeable batteries. There is a risk of explosion!
f) Power adapter
• Do not modify or repair mains supply components including mains plugs, mains cables, and power sup-
plies. Do not use damaged components. Risk of death by electric shock!
• Connect the appliance to a wall socket that can be accessed easily.
• As power supply, only use the supplied mains adaptor.
• Only connect the power adaptor to a normal mains socket connected to the public supply. Before plug-
ging in the power adaptor, check whether the voltage stated on the power adaptor complies with the
voltage of your electricity supplier.
• Never connect or disconnect power adaptors if your hands are wet.
• Never unplug the power adaptor from the mains socket by pulling on the cable; always use the grips
on the plug.
• For safety reasons, disconnect the power adaptor from the mains socket during storms.
• Do not touch the power adapter if there are any signs of damage, as this may cause a fatal electric
shock! Take the following steps:
• Switch off the mains voltage to the socket containing the power adapter (switch off the corresponding
circuit breaker or remove the safety fuse, and then switch off the corresponding RCD protective switch).
• Unplug the power adapter from the mains socket.
• Use a new power adapter of the same design. Do not use the damaged adapter again.
• Ensure that cables are not pinched, kinked or damaged by sharp edges.
• Always lay cables so that nobody can trip over or become entangled in them. This poses a risk of injury.
29

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

2389433

Inhaltsverzeichnis