Hifonics TITAN TS250R Bedienungsanleitung Seite 6

ENGLISH
POWER RATING
The HiFONICS TITAN TS subwoofer enclosures are designed for high bass
levels. Anyhow it is possible, that unsatisfying sound characteristics could be
caused by too low or too high amplifier power. In certain circumstances this
even can cause a damage to the loudspeakers.
It is recommended to choose rather a more powerful amplifier (ca. 15-20%
more Watts RMS than the max. RMS power rating of the woofer) and to use
the amplifier not at the maximum output level (low distortion factor, good sound
characteristics). A weaker amplifier at the maximum level causes worse sound
characteristics due to the higher distortion factor.
Never crank up the output volume of your amplifier to the maximum level or run
the amplifier into the clipping range. If the sound is distorted and not clean, turn
back the level until the distortions disappear.
Please note the following recommended power ratings:
TS250R
One Amplifier with approx. 240 to 360 Watts RMS @ 4 Ohms.
TS300R
One Amplifier with approx. 300 to 500 Watts RMS @ 4 Ohms.
The HiFONICS TITAN TS subwoofer enclosures have no integrated limiter or
clipper, which is limiting the level upwards. Overamplified bass peaks leads in-
evitably to a burn out of the voice coil of the woofer. A burn out of the voice coil,
caused by clipping/overamping is not covered by the usual warranty.
6