Coccolle Urbio Bedienungsanleitung Seite 10

- Damage occurred as a result of failure to observe maintenance guidelines such as:
corrosion, changed upholstery or plastic elements colour as a result of prolonged
exposure to sunlight, damage to plastic elements of upholstery as a result of
prolonged exposure to sunlight or excessive temperatures, excessive play, squeaking
/ creaking noises, damage to mechanism due to over-load.
- Damage occurred due to repairs being carried out by unauthorised personnel.
- Single wheels being pushed into a vertical position as a result of loading (this is
normal).
- Damage and soiling occurred due to the product being incorrectly packaged for
shipping (courier online purchases).
2. The repair method is determined by the manufacturer/warranty service provider.
3. The product subject to a complaint should be provided clean.
4. The consumer goods warranty does not exclude or suspend the purchaser's rights
stemming from goods noncompliance with the agreement.
Parts list
A. Main frame
B. Front fork
C. Rear wheels
D. Front wheel
E. Steering handle (lower part)
F. 1. Screw M60*30
2. Nut M6
3. Shim 6 mm
G. Handlebar
H. Backrest
Assembly steps
1. Insert the big fender(N) into the front fork(B), then insert the mudfender
accessory(P) into the front fork (B). Last, screw them up(3N*M).
2. Insert the front fork(B) into the front wheel (D), then tighten them up with M6X30
screw, M6 nut, 6MM shim.
3. Open the rear fork of the frame(A), until hearing the "click" sound.
4. Insert the rear axle(M) into the rear wheel(C), then install them into the rear fork. At
the same time, press the button on the rear fork. After that insert the rear wheel, loose
the button, and make sure rear wheel is in the right position.
5. Insert the front wheel into the frame(A).
6. Take off the screw on the handlebar(G), then insert the handlebar into the front
fork(B), last tighten them up with screw(3N*M).
7. Take off the screws under the seat(O), then install the seat on the frame, last
tighten them up with screws(3N*M).
8. Take off the screw and plastic on the foot rest(L), then install the foot rest under the
frame, last tighten them up with screw.
9. Insert the rear basket(I) into the rear fork of the frame(A).
10. Take off the screw on the backrest bracket, then insert the backrest(H) into the
backrest bracket, last tighten them up with screw.
11. Insert the bottom part of the steering bar(E) into the relevant bracket behind the
backrest, making sure it's in the right position.
I. Rear basket
J. Steering handle (upper part)
K. Canopy
L. Legrest
M. Rear axle
N. Mudfender
O. Seat
P. Mudfender accessory
Q. Cupholder
EN