Start And Stop; Operating Mode - seeger SAC9000S Gebrauchsanweisung

Conditioner" and follow the on-screen instructions. Check the status of the Wi-Fi indicator
and select the correct one. If the WiFi indicator flashes quickly, a direct connection can
be established. If the WiFi indicator flashes slowly, press "Go to connect" to connect to the
WLAN called "SmartLife-XXXX".
6.Once the device connects successfully, the Wi-Fi light will turn on. You can now control
the device from the app. Press and hold the timer button for about 5 seconds, the device
will disconnect, and the Wi-Fi light will light up.
TROUBLESHOOTING
Problem
Network connection timeout
WiFi screen off
The WLAN access point
disappears and the WLAN LED
flashes.
5.3 PARAMETERS

5.3.1 Start and Stop

Press POWER to turn on the device.
Press MODE to select the desired mode.
Press the POWER button to turn off the device.

5.3.2 Operating mode

The device has 5 or 4 operating modes: cooling, dehumidification, ventilation,
repetition, heating.
Note: Heating mode is only applicable to SAC9000HS.
Solution
1. The WLAN LED flashes slowly: Check if you have
selected the WLAN with the name "SmartLife-xxx".
2. The WLAN LED flashes slowly: Verify that you have
selected the WLAN with the name "SmartLife-xxx".
Turn off the device, disconnect it from the power
supply, and plug it back in after 10 seconds. Call the
app again to establish a connection.
Press and hold the timer button or turn off the
device, remove the plug from the power outlet and
plug it back in after 10 seconds.
Turn off the device, unplug the power cord, and plug
it back in after 10 seconds.
12
ENG