Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FUNCTION KEY
"
"
Use " " key to turn backlight on and off.
"mils/µm"
Use "mils/µm" key to switch between mils and µm.
(1 mils = 25.4 µm)
"Zero"
1. Quickly push "Zero" key (no longer than 2 seconds) for substrate zeroing calibration.
2. Hold "Zero" key to calibrate frequent calibrating point.
3. Delete all calibration readings.
4. Delete MAX, MIN, and MAX-MIN readings.
"MAX/MIN"
1. Use "MAX/MIN" key to switch maximum, minimum, max-min, average, and total counts of data log
(MAX, MIN, MAX-MIN, AVG, and NO).
2. Capacity for data log is 255. Maximum, minimum, max-min, and average calculation will not be
th
refreshed after 255
3. When power is off, hold "MAX/MIN" key and pull the trigger to enter frequent calibrating point
setting.
"CAL"
1. When power is off, use "CAL" key and pull the trigger to enter Hi/Lo limit alarm setting.
2. When power is on, use "CAL" key for one point calibration.
3. In data logging mode and frequent calibrating point setting, use "CAL" to confirm and return to
operation
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
data.
Peel off the protection films from foil and
standard coating plate before first use.
Ferrous is steel
Standard Coating Plate
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Non-ferrous is Aluminum
Werbung
Inhaltsverzeichnis
