Safety Instructions For Maintenance - Husqvarna PG 510 Bedienungsanweisung

ON/OFF switch
The ON/OFF switch is used to start and stop the
product.
To do a check of the ON/OFF switch
1. Turn the emergency stop button clockwise to make
sure that emergency stop button is disengaged.
2. Push down the handle to lift the grinding head from
the floor.
3. Turn the ON/OFF switch to 1 to start the product.
1146 - 002 - 09.12.2022
4. Wait for 5 seconds, this is to let the product operate
at the idle speed.
5. Turn the ON/OFF switch to 0 to stop the product.
Emergency stop
The emergency stop is used to quickly stop the motor.
The emergency stop at the product breaks the mains
power supply.
To do a check of the emergency stop
1. Push the emergency stop button (A) and make sure
that the motor stops.
A
2. Turn the emergency stop button clockwise (B) to
disengage.

Safety instructions for maintenance

• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Stop the motor and disconnect the power plug when
you replace the diamond tools.
B
7