Profeco Combitool kit MG12 Gebrauchsanleitung Seite 24

Operating
Before use
Remove all packing material and loose parts from the unit.
Check the accessories before use. They must be suitable for the machine and for
your purpose.
If the machine is new, the battery must be charged first.
Attention!
After long-term storage, the battery capacity will decrease.
The battery is inserted in the handle, press the release button and remove the battery
from the handle.
A significant decrease in operating time per charge indicates that the battery is worn
out and needs to be replaced.
Battery charger
The supply voltage must correspond to the voltage indicated on the type plate of the
rapid charger.
Always inspect the battery charger, cord and plug before use.
Always have damage repaired by a qualified professional.
Protect the battery charger from moisture and only use it in dry areas.
The battery charger supplied is only suitable for charging batteries.
Charging the battery pack
To start charging, insert the charger plug into the battery pack and connect the
battery charger to the mains outlet.
The battery pack and charger will become warm during charging, this is normal.
When charging is complete, unplug the charger from the power outlet and disconnect
the charger from the battery.
LED indicator on charger:
About the charger
Disconnect the power supply before connecting or disconnecting the battery
The charger must only be used with a rechargeable battery. Never use a non-
rechargeable battery.
Do not expose the charger to rain or water
On/Off trigger
Use the on/off trigger to start the machine and hold it down for continuous operation.
The rotation speed can be varied by pressing the power trigger. The more the trigger
is pulled, the faster the rotation speed.
Release the power trigger to turn the machine off.
red indicator: charging.
Green indicator: charging complete.
24