Operation; Before Initial Operation; Emperature Setting - Pkm GT300E Bedienungsanleitung

When the appliance is not levelled, the door and the door seal will not close
properly.

4. Operation

❖ The appliance can be used as fridge or freezer (detailed description: see the
following chapters).
WARNING! To disconnect the appliance from the mains, you must
unplug the appliance or use a cut-off device.

4.1 Before initial operation

WARNING! While unpacking, the packaging materials (polythene
bags, polystyrene pieces, etc.) should be kept away from children and
pets. CHOKING HAZARD! RISK OF INJURY!
NOTICE! Leave the appliance in an upright position for at least 4 - 6 hours
before you connect it to the mains to ensure, that the oil has flowed back
into the compressor.
NOTICE! If you use the appliance for the first time or the appliance has
been disconnected from the mains for a longer period of time, allow the
appliance to cool down for 3 until 4 hours at following temperature setting
before you place any fresh or frozen food in the appliance: fridge mode =
+4 °C / freezer mode = -18 °C (s. chapter 4.6 T
seq.). If you place food in the appliance before it has reached its normal
operating temperature, the food can thaw and / or spoil.
1. Remove all packaging materials.
2. Adjust the feet and clean the appliance (see chapter
MAINTENANCE
3. Do not start the appliance immediately after installation. Wait at least 4 - 6 hours
to ensure proper operation.
4. Connect the appliance to the mains properly.
5. The cooling or freezing temperature of the appliance can be adjusted manually
by pressing the relevant buttons until the desired cooling or freezing temperature
is indicated on the display (s. chapter 4.6 T
6. The noise generated by the compressor and the gases / liquids of the appliance is
normal.
7. If operation was interrupted, wait at least 5 minutes before restart.
).

EMPERATURE SETTING

~ 64 ~
EMPERATURE SETTING
CLEANING AND
et seq.).
et