Error Indicators - Hyundai HHA282104 Bedienungsanleitung

Measuring procedure:
After the cuff has been appropriately positioned.the measurement can
begin:
1) Press the START/STOP button, all symbols appear on the display,
you can hear 2 short beep after O flash for 2
seconds, then the pump begins to inflate the cuff,
the rising pressure in the cuff Is shown on the
display.
2) After the suitable pressure has been reached, the
pump stops and the pressure gradually falls T he
cuff pressure 1s displayed In case that the inflation
is not sufficient the device automatically re-Inflates
to a higher pressure
3) When the device detects the signal, the heart
symbol on the display starts to flash, you can hear
the beep for every heartbeat once the heartbeat
signal 1s detected
4) When the measurement has been completed,
you can hear a long beep, in the meantime , the
systolic. diastolic and pulse rate will appear on the
display.
5) The measurement readings remain on the display
until you switch off the device. If no button is pressed for a period of
3 minutes, the device switches off itself in order to save the power.
Note:
It will read in kPa as unit when you choose kPa. The symbol will be
displayed along with the reading if the irregular heartbeat is detected
during the measurement.
Discontinuing a measurement
If it is necessary to interrupt a blood pressure measurement for any
reason (eg. the patient feels unwell) the START/STOP button can be
pressed at any time. The device immediately decrease the cuff
pressure automatically.
Memory-recall of measurements
This blood pressure monitor automatically stores 1 * 199 sets
measurements value, the oldest record will be replaced by the latest
measurement value when more than 199 sets each user.
Read memory record
Press the button when power off, the last measurement value will be
shown, as well as subsequent measurements can be display one after
the other by pressing the button
Memory -clear of measurements
If you are sure that you want to permanently remove all stored
memories. press the button
button then all the records will be cleared.
About blood pressure
Blood pressure is the pressure exerted the arteries. The systolic blood
pressure value represents the blood pressure produced by contraction
of the heart muscle. The diastolic blood pressure value represents the
blood pressure produced by relaxation of the heart muscle.
• According to the blood pressure classification by the WHO/ISH.
• SYS lower than 100mmHg(13. 3kPa) is considered as hypotension.
each time.
until it is shown CL, after this press
• Blood pressure type 120 130 140 160 180

ERROR INDICATORS

• The following symbol will appear on the display when measuring
abnormal.
TROUBLESHOOTING
CARE FOR THE MAIN UNIT AND BLOOD PRESSURE MONITOR CUFF
• Keep the unit in the storage case when no use.
• Clean the unit with soft dry cloth. Do not use any abrasive or volatile
cleaners.
• Never immerse the unit or any component in water.
• Make sure the monitor is off prior to cleaning, a mixture of distilled
water and 10 percent bleach could be used.
• Using a spray bottle, moisten a soft cloth towel with the bleach or
detergent mix until it is fully saturated. Squeeze any excess moisture
from the cloth to avoid any dripping or potential oversaturation of the
cuff.
• Wipe all surfaces of the blood pressure monitor cuff thoroughly,
making sure to clean the inside and outside of the cuff. Be cautious
not to get any moisture in the main unit.
• Using a dry cloth, gently wipe away any excess moisture that may
remain on the blood pressure cuff. Lay the cuff flat in an unrolled
position and allow the cuff to air dry.
MAINTENANCE
• Do not clean the body and cuff With naphtha, thinner or gasoline etc.
• Do not wet the cuff or attempt to clean the cuff with water.