Sonoro ORCHESTRA STAND SO-1300 Bedienungsanleitung Seite 21

2. Attach the front foot bar and
H
stand frame. Make sure that the foot bar with the sonoro logo is attached at the
front.
3. Insert the 4 grub screws into the tapped holes of the
C
rear foot bar.
4. Tighten the 4
C
5. Feed the speaker cable through the lower cable opening into the cable guide on
the rear tube of the speaker stand. Pull the cable through until the speaker cable
reaches the connection sockets of your ORCHESTRA speakers.
© sonoro audio GmbH 2023
rear foot bar by sliding them on to the
G
grub screws by hand using the
front foot bar and
H
3 mm socket head wrench.
F
A
GB
G
21