Troubleshooting
28
If the Power Station fails to charge or power devices, check the following steps:
– Make sure the general Power ON/OFF button is ON . The buttons are green .
– Check the battery capacity . If it is less than 3%, charge the Power Station .
– Make sure that the power consumption does not exceed the rated power of the
connection .
– If an error code occurs, refer to the error code table on the next page .
– Do not operate the Power Station outside the permissible operating temperature .
(-10 – 40° C) .
Error Codes
Input overvoltage protection: The symbol flashes for 5 seconds when an
input overvoltage is detected .
Output overload protection: The symbol flashes for 5 seconds when an AC
output overload is detected .
Low power alarm: The icon flashes when the Power Station battery capaci-
ty is less than 3% .
Low temperature alarm: The low temperature symbol is displayed when an
attempt is made to use the Power Station outside the permissible opera-
ting temperature .
High temperature alarm: This high temperature symbol is displayed when
an attempt is made to use the Power Station outside the permissible
operating temperature .
ENGLISH