Heissner F636-PXC Gebrauchsanleitung & Garantie Seite 13

Use as wet and dry vacuum cleaner (only in manual operation Fig. B switch position I)
For wet and dry suction operation, the tank is closed by means of a closure cover on the lower connec-
�
tion nozzle instead of the drain hose.
Automatic operation not permitted (Fig. B Switch position II): For safety reasons, the device should
�
not be used in automatic mode when used as a wet and dry vacuum cleaner, i.e. in operation
with a closure lid.
Troubleshooting
Possible malfunction
Vacuum cleaner does not vacuum
in pond sludge vacuum cleaner
operation.
Suction power weak, does not
suck (wet/dry operation and pond
sludge vacuum cleaner operation)
Suction power weak, does not
suck (wet/dry operation and pond
sludge vacuum cleaner operation)
Suction power weak, does not
suck (wet and dry operation)
Vacuum cleaner does not empty Rubber flap in drain hose C
Vacuum cleaner does not empty
completely in automatic mode
Water leaks out of engine head
(wet operation)
Smoke generation from engine
head (dry operation)
GUARANTEE
These warranty conditions govern additional warranties. Statutory warranty claims are not affected by
this guarantee. The guarantee begins on the day of purchase by the end user, which must be proven by
presenting the warranty card and / or proof of purchase (receipt, receipt). The warranty service extends
exclusively to defects that are due to material or manufacturing defects. Warranty service is provided by the
free repair of the returned product or by replacement of a faultless device at our discretion. If an identical
product is no longer available in the range of HEISSNER GMBH, the warranty can be provided by delivering
a product with comparable technical features. Warranty service is only valid if the product has been handled
properly and according to the recommendations in the instructions for use. Excluded from the claim for
warranty service are damages caused by improper installation, abusive or improper use, non-observance
of safety regulations, inadequate maintenance as well as the use of force or external influences, unauthor-
ized changes to the product, as well as normal wear and tear during intended use. In particular, transport
damage as well as consequential damage and costs of defects are excluded from the claim for warranty
F636-PXC Anleitung.indd 13 F636-PXC Anleitung.indd 13
Cause
Rubber flap in drain hose C not
present/closed.
Hose nozzle or handle on suction
hose L loosely.
Motor head not closed.
Cap F for wet and dry operation
not mounted.
does not close properly (dirty /
blocked).
Depending on individual operat-
ing conditions and suction height
Filter sponge R via float cage
in engine head not mounted or
fallen off.
Filter sponge R via float cage in
the engine head not mounted
or fallen off, thereby dust suction
into the engine area.
Remedy
Check the rubber flap at the be-
ginning of the drain hose C, if
necessary. Remove contamina-
tion.
Screw the connection nozzle or
handle flush onto suction hose L.
Place the motor head flush, close
the locking clips.
Fitting cap F.
Remove dirt / contamination, if
necessary. Disassemble drain hose
C and reattach it.
Install drain hose with slope. In
automatic mode, switch off the
vacuum cleaner briefly if neces-
sary and empty it manually. Then
turn it back on.
Mount filter sponge R over
sponge cage . After prolonged op-
eration, if necessary. Filter sponge
dry beforehand.
Mount filter sponge R over float
cage.
1 EN
13
04.11.22 16:26 04.11.22 16:26