ATOMSTACK Air Assist Kit Benutzerhandbuch Seite 5

If your model is AtomStack A5 Pro+ or AtomStack P7 M40, you need to choose one of
the following 2 combinations to support your model.
11
1. Remove the
2. Remove the
set screw from
current air guide
the right side of
hood.
the laser and
remove the
current filter
glass or acrylic
shield.
NO. 1
NO. 1-3 NO. 2
Combination two
Combination one
locate the
combination which
contains the wind
deflector matches
your model( If the
bottom surface of
the glass and the
laser is flush after
assembly, proves
this wind deflect
matches your
model), choose this
combination.
3-1 3-2
NO. 2-1
4. Install the
combination matches
your model, mount the
air guide hood and the
glass at the same time.
5. Insert the tube.