FITO PRODUCTS CO2-O2 Installations- Und Einrichtungsanleitung Seite 37

Wall-mounting:
• Select the suitable installation location for the Air Quality Monitor. Check that there are no
pipes running into the walls at the location.
• Remove the mounting bracket by turning it counter clockwise .
• Mark the mounting holes in the bottom plate and drill the holes ( use a 5 mm drill bit). The
depth required is 30 - 40 mm.
• Place the dowels in the holes and fix the screws in the mounting bracket.
• Turn the Air Quality Monitor on the mounting bracket, clockwise.
• See below schematic drawing of the wall mounting..
Functionalities:
Light and sound alerts:
The default warning value of CO2 concentration is set to 1000 PPM and the alarm value to
1500 PPM.
•
When the concentration of CO2 is lower than 1000 PPM, the LED indicator will be green in
colour.
•
When the concentration of CO2 is higher than 1000 PPM but lower than 1500 PPM, the LED
indicator will be yellow in colour.
•
When the concentration of CO2 is higher than 1500 PPM, the LED indicator will be red in
colour. The Air Quality Monitor will also sound an audible alarm with voice alarm.
- 37 -