Herunterladen Inhalt Inhalt Diese Seite drucken

Hisense RS18N4TCE Bedienungsanleitung Seite 53

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
23
Water storage box cleaning
You should clean the water storage
box regularly. You can remove the
water storage box along horizontal
outward, and then disassemble the
cover of box. Wipe the inside of the
box and cover with a weak solution of
bicarbonate of soda, and then rinse
with warm water using a wrung-out
sponge or cloth, clean it with directly
drinking water again. Thoroughly dry
all surfaces and removable parts
before putting them back into place.
You can assemble the water storage
box along horizontal forward when you
finish cleaning.
Although this appliance automatically
defrosts, a layer of frost may occur on
the freezer compartment's interior
walls if the freezer door is opened
frequently or kept open too long. If the
frost is too thick, choose a time when
the freezer is nearly empty and
proceed as follow:
1. Remove existing food and
accessories baskets, unplug the
appliance from the mains power and
leave the doors open. Ventilate the
room thoroughly to accelerate the
process.
2. When defrosting is completed,
clean your freezer as described
above.
Warning!
Do not use sharp objects to remove
frost from the freezer compartment.
Only after the interior is completely
dry should the appliance be switched
back on and plugged back into the
mains socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause
seals to stick to the cabinet and tear
when you open the door. Wash the
seals with a mild detergent and warm
water. Rinse and dry them thoroughly
after cleaning.
Warning!
Only after the door seals are
completely dry should the appliance
be powered on.
Replacing the LED light
Warning: The LED light must be
replaced by a competent person. If
the LED light is damaged, follow the
steps below:
1. Unplug your appliance.
2. Remove light cover by rising up
and puling out the LED light.
3. Hold the LED light with one hand
and pull it with the other hand while
pressing the connector latch.
4.Replace LED light and snap it
correctly in place and recover the light
cover.
NOTE:
This product contains a light source
of energy efficiency class <G>.

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Rs18n4tieRs18n4tcfRs694n4td1Rs694n4tf1

Inhaltsverzeichnis