Smart Mode - Hisense J1-06 Bedienungsanleitung

Operation instructions
SMART mode (invalid for some models)
Press the SMART button, the unit enters SMART mode(fuzzy logic operation) directly regardless of
the unit is on or off. In this mode, temperature and fan speed are automatically set based on the
actual room temperature.
For the split-type models, such as wall-mounted air conditioners and some floor-standing air conditioners,
their operation mode and set temperature should be determined based on the indoor temperature.
Operation mode and temperature are determined by indoor temperature
Heat pump models
Indoor temperature
21℃ or below
21℃-23℃
23℃-26℃
Over 26℃
Cooling only models
Indoor temperature
23℃ or below
23℃-26℃
Over 26℃
For commercial air conditioner products, such as cassette type air conditioners, duct type air conditioners,
ceiling & floor air conditioners and some floor-standing air conditioners, their operation mode should be
determined based on the difference between the indoor temperature and set temperature.
The operation mode is determined by the difference between the indoor
Heat pump models
Indoor temperature
T-3℃
Cooling only models
Indoor temperature
T+3℃ or below
SMART button is ineffective in SUPER mode. Press MODE button cancel SMATR mode.
Note: Temperature, airflow and direction are controlled automatically in SMART mode. However, For the on/off, you can
choose from -2 to 2 (for some models you can choose from -7 to 7), for the inverter you can choose from -7 to 7. if you
still feel uncomfortable.
Operation mode
HEATING
FAN ONLY
COOLING
Operation mode
FAN ONLY
COOLING
temperature and set temperature.
Operation mode
Below T-3℃
≤T ≤
T+3℃
FAN ONLY
indoor
Over T+3℃ COOLING
Operation mode
FAN ONLY
COOLING
Over T+3℃
Target temperature
22℃
Room temperature
DRY decrease 2℃ after
operate for 3 minutes
26℃
Target temperature
Room temperature
DRY decrease 2℃ after
operate for 3 minutes
26℃
Target temperature
HEATING
Target temperature
5
T
T
T
T
T