Gecko DEVIALET Bedienungsanleitung Seite 2

To avoid the risk of falling, fire and electrocution,
please read the following instructions carefully.
Any unauthorized modification could compromise your safety and prevent the
device from being used as intended.
If you experience any problems, please consult an expert.
For your safety, make sure that a disconnecting device (switch or circuit breaker)
is installed and easily accessible.
In a thunderstorm, turn off the power supply.
Make sure that your electrical installation complies with all the electrical standards
applicable in your country.
— Make sure that the wall on which the GECKO REACTOR wall mount is to be
installed is level, smooth and vertical.
— Make sure that the wall on which the GECKO REACTOR wall mount is to be
installed is not damaged and is able to support 22 lbs. at the fixing point.
— Only use the screws and dowels provided by DEVIALET for fitting the GECKO
REACTOR.
— For each mount type, use the screw and dowel combination stated below.
— When drilling into the wall, make sure that the drill bit has the correct diameter
and is suitable for the mount.
— It is important that the screws are secured to the wall properly to ensure that
the device is held in place.
— Installation should always be carried out by two people.
2