Kress KUB61 Originalbetriebsanleitung Seite 10

LED indication
Before operation, the LED light
will be activated when the On/Off
switch is slightly depressed, and will
automatically turn off 20 seconds after
the On/Off switch is released.
Both the impact starter and the battery
are equipped with protection systems.
When the LED flashes (about once
every second, it will stop flashing when
you release the switch), the system will
automatically cut off the power of the
tool to prolong the battery life.If the
machine and battery pack are placed
in the following locations, the machine
may automatically power off during
operation:
• Overload: If the tool is overloaded, the
abnormally high current may be released;
in this case, release the switch on the tool
to stop the overloading operation; and
then restart.
• Overheat: When the above situations
occur, if the tool fails to start by pressing
the switch, the tool and battery will
overheat. In this case, cool the tool and
battery pack before starting the switch
again.
• Low voltage: The tool does not work
when the remaining capacity is too low. In
this case, remove and replace the battery
10
pack.
EN
WARNING: To turn on the light,
press the On/Off switch and make
sure the Forward/Reverse Rotation
Control is on right/left position.
See Fig. D