Assembly And Installation - LIVARNO home 1033-S Bedienungs- Und Sicherheitshinweise

z Assembly and installation
DANGER OF OVERHEATING! Do
not operate the product while it is
still inside the packaging!
NB: Take the product out of its packaging
and remove all packing material�
Check that all package contents are
„
present�
Check if the product or individual parts are
„
damaged� If that is the case, do not use the
product� Contact the distributor via the
service address given in the warranty
section�
DANGER OF INJURY!
If the product is not secured
properly it may tip over and cause
injury�
Do not place the product on a surface that
„
is not flat.
Make sure that the ground sufficiently flat
„
when using the ground spike�
Make sure that the ground spike is also
„
removed when taking out the product so
that there is no risk of tripping�
LED star (1033-S) with stand
RISK OF DAMAGE! Before setting
up the product on the pedestal,
protect sensitive surfaces�
Place the LED star
„
attach the two together firmly using the
hand screws (see Fig� A)�
3
Place the product on a flat surface. Make
„
sure that the stand is stable�
NB: Make sure that the hand screws
firmly attached.
LED star (1033-S) with ground spikes
Attach the individual ground spikes
„
the LED star and fix in place by
1
fastening the screws
hand (see Fig� B)�
NB: Ensure the ground spikes are facing the
10
GB
on the stand and
1 2
are
3
to
4
on the spike by
3
right direction (angle of the openings) as
shown in Fig� B�
Insert the product into the surface, e�g�
„
lawn/soil etc�
NB: Make sure the product is firmly
attached� Do not use force, e�g� a hammer,
during assembly or installation� This could
damage the product�
Setting up the LED tree (1033-T) with
stand
RISK OF DAMAGE! Before setting
up the product on the pedestal,
protect sensitive surfaces�
Using the two screws
„
underneath the LED tree
12
E)�
Place the product on a flat surface. Make
„
sure that the stand is stable�
Setting up the LED tree (1033-T) with
ground spike
Using the two screws
„
spike underneath the LED tree
14
Fig� F)�
Insert the product into the surface, e�g�
„
lawn/soil etc�
NB: Make sure the product is firmly
attached� Do not use force, e�g� a hammer,
during assembly or installation� This could
damage the product�
Connect power supply
RISK OF ELECTRIC SHOCK!
Plug the connector
„
the mains plug
8
Tighten the union cap
„
thread of the connection socket
Plug the mains plug
„
has been correctly installed�
NB: When using outdoors, plug the mains
plug in to an IPX4 socket to ensure splash
8
protection�
, fasten the stand
13
(see Fig�
11
, fasten the ground
13
(see
11
into the socket
5 7
(see Fig� C)�
on the screw
6
�
7
into a socket that
8
of