Mounting; First-Time Operation; Operation - LIVARNO home 1105-W Bedienungs- Und Sicherheitshinweise

TRIPPING HAZARD! Ensure that
the power cable
rope light
1
a way that nobody can tread on or trip over
them�
Mounting safety
instructions
Ensure that the product is only mounted by
„
competent persons�
The product can be fixed to any normally
„
flammable surface with the mounting
equipment included in the package�
RISK OF ELECTRIC SHOCK!
Decide where the product is to be
mounted prior to mounting� Before
drilling the fixing holes, satisfy yourself that
there is no danger of drilling into or
damaging gas or water pipes or electricity
cables in the position where you are about
to drill the holes� Use a drill to drill the holes
into the masonry�
Before mounting, check that the substrate is
„
suitable for the mounting equipment and
the weight of the product� If you are unsure
about anything, seek the advice of an
electronics specialist�
Do not use sharp and/or pointed objects
„
such as wire, nails or staples to mount the
product�
Do not hang any additional items on the
„
product�
Avoid excessive bending of the LED rope
„
light � This will damage the insulation�
1
The bend radius of the rope light must not
„
exceed 2 cm�
Avoid excessive heating of the product� No
„
more than two sections of rope should cross
one another or run parallel to one another�
z Mounting
Please note: Take the product out of its
packaging and remove all packing material�
10
GB
and the LED
2
are positioned in such
Check that all package contents are present�
„
Check if the product or individual parts are
„
damaged� Should you detect damage, do
not use the product� Please contact the
retailer via the service address indicated�
Unwind the LED rope light
„ „
(see Fig� B)�
7
Fix the LED rope light to the desired surface
„ „
using the cable ties
A)�
Alternatively, you can use the mounting
„ „
clips included in the package to fix the
6
product in place (see Fig� A)�
To do this, start by screwing the mounting
„ „
clips into a stable substrate with the
6
screws provided, using a Phillips
4
screwdriver (not included in package)�
Push the LED rope light into the openings of
„ „
the mounting clips
If necessary, you can also fix the LED rope
light to the mounting clips
cable ties �
5
z First-time operation
TRIPPING HAZARD! Ensure that
the power cable
rope light
1
a way that nobody can tread on or trip over
them�
Plug the mains plug into a socket that has
„ „
been correctly installed�
Please note: When using the product
„ „
outdoors, use an IPX4 socket for the mains
connection to ensure splash protection�
z Operation
Press the button
„ „ 3
product on (see Fig� A)� Once the product
is switched on, the button will light up
green and the product will light up
permanently�
Press the button
„ „
3
timer function� When the timer function is
from the reel
1
provided (see Fig�
5
fixed to the substrate.
6
using the
6
and the LED
2
are positioned in such
once to switch the
again to activate the