Solving Problems; Additional Remarks; Environmental Protection; De Original (Betriebsanleitung) - NEO TOOLS 90-161 Originalbetriebsanleitung

Button Function
"ON / Switching the device on and off.
OFF"
+ or - Increasing or decreasing the value depending on the
selected setting mode - change of time (0 to 24 hours) or
humidity (RH10% to 95%).
"Timing" A short press turns on the cyclic operation.
FUNCTIONS
Moisture control
Drying the air to the set humidity level results in the automatic shutdown
of the compressor and the fan. If the desired humidity level is set to the
minimum, the dehumidifier enters the continuous operation mode.
When the device is turned on, the compressor starts after 3
seconds. When the device is turned off, the fan turns off after three
seconds.
If the humidity reaches a level low enough to turn off the compressor, the
fan will turn off after 1 minute.
Security
The device has security systems to protect it against damage during
operation.
 After turning off the device and restarting it, it takes 3 minutes for the
device to start up.
 If the temperature read by the ambient temperature sensor remains
no more than 3 degrees above the exchanger temperature for 10
seconds in a row, the equipment is considered damaged due to
leakage or damage to the tube. The warning "Pressure Holding" will
be displayed. The cause of the damage must be eliminated before
restarting the dryer.
 Save settings: in the event of a sudden shutdown of the device due
to accidental disconnection from the power supply or a power failure,
the dryer settings are saved in the device memory and applied after
restarting.
Defrosting
Defrost Description
mode
Automatic The sensors Defrosting is started when the compressor is running for
defrosting are normal 20 minutes or the exchanger temperature is kept below 0
° C for more than 30 minutes.
Defrosting is completed when the exchanger temperature
exceeds 5 ° C for 90 seconds, or when the defrosting time
exceeds 8 minutes.
Time Exchanger Defrosting will not start if the ambient temperature is
defrosting sensor error above 25 ° C.
In the ambient temperature range from 15 to 25 ° C, the
compressor works in a cyclical mode: 30 minutes of work,
10 minutes of defrosting.
In the ambient temperature range from 4 to 15 °, the
compressor works in a cyclical mode: 20 minutes of
operation, 12 minutes of defrosting.
Humidity Defrosting is started when the compressor is running for
sensor error 20 minutes or when the temperature of the exchanger
remains below 0 ° C for more than 20 minutes.
Defrosting is completed when the exchanger temperature
exceeds 5 ° C for 90 seconds, or when the defrosting time
exceeds 25 minutes.
Both sensors The compressor runs for 40 minutes, then enters the
failed defrost mode for 10 minutes.
Timer
It is possible to set the time after which the dehumidifier starts and stops
working.
 When the device is turned off, press the "Timing" button to set the
time after which the device will turn on. You can increase or
decrease the time from 0 to 24 hours by pressing the add or subtract
button. By pressing the add or subtract button for 2 seconds, the
value can be increased or decreased continuously. Confirmation of
the setting takes place automatically after 10 seconds without
pressing any buttons.
 During the operation of the device, it is possible to set the time after
which the device ends its work in a similar way.
 By setting the on and off times, the device will cycle on and off.

SOLVING PROBLEMS

Problem or Possible cause
error code
Device unable With the No power.
to work. device
The
turned off.
properly connected to
the socket.
Defective transformer. Replace transformer.
Defective fuse
With the The humidity level is
device lower than the set
turned on. level.
Recommended solution
Check the mains power status.
plug is not Properly insert the plug into the
socket.
Replace the fuse.
Set the humidity
needed.
Low
dehumidification
efficiency.
Loud work.
Water leak.
Error E1
E2 / E3 error
EE
Note: A moderate level of noise when the dehumidifier is in operation and
warm exhaust air are normal and should not be a worry.

ADDITIONAL REMARKS

 The humidity sensor may be damaged in contact with an aggressive
or dusty environment. Temperature conditions can affect the
accuracy of the reading.
 To extend the life of the device, press the buttons as softly as
possible.
 The dehumidifying effect will be faster in environments with high
humidity and temperature. As the temperature and humidity
decrease, the operating speed decreases.

ENVIRONMENTAL PROTECTION

Electrically powered products should not be disposed of with household
waste, but should be disposed of in appropriate facilities. Information on
disposal is provided by the dealer of the product or local
authorities. Waste
substances that are not neutral for the natural environment. Non-recycled
equipment is a potential threat to the environment and human health..
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with its
registered office in Warsaw, ul. Pograniczna 2/4 (hereinafter: "Grupa Topex") informs that
all copyrights to the content of this manual (hereinafter: the "Manual"), including its text,
photos, diagrams, drawings, and its compositions belong exclusively to the Topex Group
and are subject to legal protection in accordance with the Act of February 4, 1994, on
copyright and related rights (i.e. Journal of Laws of 2006 No. 90 Item 631, as amended).
Copying, processing, publishing, modifying for commercial purposes the entire Manual
and its individual elements, without the consent of Grupa Topex expressed in writing, is
strictly prohibited and may result in civil and criminal liability.
VORSICHT: BEVOR SIE DAS ELEKTROWERKZEUG VERWENDEN,
LESEN SIE DIESES HANDBUCH SORGFÄLTIG DURCH UND
BEWAHREN
NACHSCHLAGEN AUF.
Hinweis: Dieses Gerät darf von Kindern im Alter von mindestens 8 Jahren
und von Personen mit eingeschränkten körperlichen und geistigen
Fähigkeiten sowie von Personen mit Unerfahrenheit und Kenntnissen des
Geräts verwendet werden, vorausgesetzt, dass die Aufsicht oder die
Einweisung in die Verwendung des Geräts in einem Safe erfolgt damit die
Gefahren verständlich waren. Kinder sollten nicht mit dem Gerät
spielen. Kinder ohne Aufsicht sollten das Gerät nicht reinigen und warten.
Detaillierte Sicherheitsbestimmungen:
 Alle Reparaturen sollten in einem autorisierten Servicecenter
durchgeführt werden.
 Nicht in der Nähe von Hitze oder Feuer verwenden.
 Nicht in der Nähe von Chemikalien verwenden.
 Nicht in explosionsgefährdeter Umgebung verwenden.
 Nicht in Kontakt mit Wasser verwenden. Nicht mit nassen Händen
verwenden.
 Das Kühlsystem enthält Kühlmittel R290. Die Komponenten des
Kühlkreislaufs nicht durchstechen.
 Stellen Sie sicher, dass sich das Gerät innerhalb des empfohlenen
Mindestabstands zu Wänden und anderen Hindernissen befindet.
 Lufteinlass und Luftauslass müssen frei bleiben.
 Das Gerät muss aufrecht stehen
 Nicht direktem Sonnenlicht aussetzen.
 Nur
innerhalb
level as
Umgebungstemperaturbereichs verwenden.
4
The device is
defrosting.
Obstruction at air discharge or
inlet.
Open windows or doors.
Ambient temperature too low.
The substrate is uneven and flat or
the dryer is in an unstable position.
The dehumidifier is on a slope
The drain or plug is damaged.
Compressor error.
Humidity or temperature sensor
error.
Coolant leak.
electrical and electronic
DE
ORIGINAL (BETRIEBSANLEITUNG)
TROCKNER
90-161
SIE DIESES HANDBUCH
des in der
Wait for the defrosting process to
be completed.
Remove the obstacle.
Close doors and windows.
Do not run the dryer when the
temperature is too low.
Move the dehumidifier to
another place, on a flat and
stable surface.
Move the dehumidifier to a level
surface.
Remove the front cover and
repair or replace the damaged
component.
Start timed defrost mode.
Replace defective sensor.
Contact an authorized service
center.
equipment contains
FÜR ZUKÜNFTIGES
Anleitung angegebenen