RONDELL RDE-1107 Betriebsanweisung Seite 19

Malfunction Possible reason
Instead of coffee water Coffee beans are not sufficiently
drips from the coffee ground
supply block
Coffee beans are wet
The coffee machine dis- The brewing unit has been
plays a notification that inserted incorrectly
there is no brewing unit
although it is installed in
the machine body
The coffee spout pro- The water supply system is
duces too little coffee clogged with the residual scales
The milk is not frothing The milk frother is clogged
The milk frother has been
installed incorrectly
The frothed milk control knob
(15) is set to the position «Hot
milk»
The milk is not frothing This type of milk is not suitable
for frothing
Milk is not flowing into The frothing and supply system
the frothing and supply is blocked
system
The milk supply pipe is installed
improperly
The coffee maker display The coffee grounds container
shows the message that sensor is blocked
the used coffee grounds
container is not installed,
though it is installed to
its place
The display shows the The water tank is empty
icon «Water tank»
The water level sensor requires
calibration
Solution
Adjust the coffee grinder settings to «+»
Replace the coffee beans with well-dried ones
Check the brewing unit and reinsert it in accordance
with this guide
Descale the coffee machine in accordance with this
guide
Fully clean the milk system and milk tubes.
Check the milk frother and reinstall it in accordance
with this guide
Turn the control knob (15) counterclockwise to the
position «Frothed milk»
For best results, use whole milk
Clean the frothing and supply system fully following
this guide
Re-check the installation of the milk supply pipe, it
must be tightly fitted to the inlet of the milk system
Remove the used coffee grounds container and
thoroughly clean all corners of the container area
with the soft brush supplied with the unit, and clean
all outer corners of the container with a dry cloth.
Fill the water tank with clean water and install it into
the socket behind the left door of the coffee maker
and press until clicking
While the coffee maker is in the standby mode,
perform the following actions: 1) Remove the water
tank from the coffee machine socket; 2) Remove
the sticker from the water level sensor reset button,
it is located in the corner of the water tank socket;
3) Press the reset button for more than 6 seconds;
4) Unplug the coffee machine from the mains;
5) Connect the coffee machine to the mains and
switch it on after 10 seconds; 6) Fill the water tank
and place it in the socket behind the coffee machine
left door, press on it until bumping
19