How It Works - Carrera EVOLUTION GO!!! 20071590 ELECTRONIC LAP COUNTER Montage- Und Betriebsanleitung

Assembly
1
Pull out the lap counter to the width of the track being used (fig.
Insert the sides of the track into the projections on the inside of the
feet of the lap counter.
Lining up the vehicles
1
Line up the vehicles in the direction of driving (fig.
are close to the light barrier (fig. ) of the lap counter.
2
1
2
The lap counter recognizes a vehicle when it passes through the
light barrier. Lap races
you can set a maximum of 999 laps, or 59 minutes and 59 seconds.
).
1
einstellen.
2
All settings and displays are undertaken via the two buttons
. During and after a race, various information on the race can be
E
called up via the
E
1 ) so that they

How it works

or time trials can be executed. Here
1 2
Settings
C D E
C and
button.
Switching on
050 050
1
00:44:28 00:44:28
Push the power switch into the ON position. The display shows
D
the active racing mode (fig. , flashing).
1
Set race mode
050 050
1
00:44:28 00:44:28
050 045
2
05:00: 00:44:28
After switching on the lap counter, this is automatically put into lap
mode (fig. ). On initial commissioning, the lap count is set to 50.
1
The lap counter saves the last lap count set and displays this again
when next called up. In order to switch to the time mode (fig.
press button once. The time display will start to flash. On initial
E
commissioning, the time is preset to 5 minutes. The lap counter
saves the last time set and displays this again when next called up.
NOTE: If no entry takes place for approximately 10 minutes, the
lap counter will switch off again automatically.
),
2
9