Automatic Shutdown; Technical Specifications - Carrera EVOLUTION GO!!! 20071590 ELECTRONIC LAP COUNTER Montage- Und Betriebsanleitung

False start function
If a vehicle drives through the light barrier prior to the start of the
race, a false start in signalled in the appropriate lane (fig.
countdown then has to be triggered again by pressing the
1
Stop race
A race in progress can be terminated at any time by pressing the
button. If laps have been driven prior to the termination, the last
C
lap completed by the respective car prior to stopping the race is
considered the end of the race.
End of race
The end of the race is achieved when both vehicles have completed
the set number of laps or the race time expires. At the end of the
race, a finish line fanfare will sound and the display will flash. Infor-
mation (fig. ) on the race will be shown on the display.
1
010 010
1
L0:08:56 L0:06:14
Call up race information
After and during a race, various racing information can be called up.
). The By pressing the button, it is possible to switch through the dis-
1 E
button). plays.
C
Time of last lap driven – Last Lap (fig.
010
1
L0:08:56
Total driving time – Total Time (fig.
010
2
05:13:07
Fastest lap driven – Fastest Lap (fig.
010
3
Fo:05:16
Deficit in comparison to leading vehicle (fig.
010
4
P0:58:16
Position of vehicles (fig.
5
010
5
L0:18:56
Number of laps more than 999
)
If the lap count of 999 is exceeded during a time trial, this will be
1
shown in the form of three arrows (fig.
010
and assessment of the result takes place in the background.
L0:06:14
)
2
If no car passes through the lap counter or no key is pressed for a
010
period of 10 minutes, the lap counter will switch off automatically in
order to save power. You can return to the Enter mode by pressing
the ON/OFF switch.
05:41:29
)
3
010
In case of malfunctions, first all 4 batteries must be inspected and if
applicable replaced.
F0:05:35
Only set up the lap counter over straight rails which lie flat.
The transmitter and receiver diodes may not be covered by rail ma-
terial or other objects.
) Direct light irradiation on the sensors can cause a fault and malfunc-
4
tion of the lap counter
010
00:01:54
) Current source: 4 x 1,5 V Mignon batteries (type AA/R6/LR6)
010
Track width: min. 110mm – max. 210mm
L0:28:56
010 010
6
L0:08:56 L0:06:14
). The internal lap count
6

Automatic shutdown

Driving tips

Technical specifications

11