RUSTA 864011660101 Gebrauchsanweisung Seite 5

STEP 1 – Nape of the neck (Diagram A)
• Set the comb position between 3 mm and 6 mm.
• Hold the clipper with the blade teeth pointing upwards.
Begin starting at the centre of the head at the base of the neck.
• Slowly lift the clipper, working upwards and outwards through
the hair, trimming just a little at a time.
STEP 2 – Back of the head (Diagram B)
• Set the comb position at 12 mm or 17 mm, cut the hair at the
back of the head.
STEP 3 – Side of the head (Diagram C)
• Set the comb position between 3 mm and 6 mm, trim sideburns.
Then change to the longer setting (12 or 17 mm) and continue
to cut to the top of the head.
STEP 4 – Top of the head (Diagram D)
• Set the comb position between 17 mm and 22 mm, cut hair
on top of the head against the direction in which the hair
normally grows.
• For longer hair on top, use without comb attachment. Lift the
hair on top of the head with a small hand comb. Cut over the
hand comb with the hair lifted or hold the hair between the
fingers to lift it and cut it to the desired length.
• Always work from the back of the head.
A
D
G
5
B
E
C
F