Operation Of The Device - neno Luna Bedienungsanleitung

5. Mode
6. Increase time/temperature
7. Power supply

05. OPERATION OF THE DEVICE

1. The device will automatically go to sleep when the plug is inserted into
the socket.
2. Press the power button to turn the device on or off. When turned on, the
function indicators will illuminate on the screen.
3. Press the „Mode" button to select the quick heat, reheat/thaw, reheat food
or sterilise functions.
a. Fast heating: insert the basket into the steriliser, pour in 40 ml of distilled
water and then insert the feeding bottle and replace the lid. Press the
„Mode" button until „Fast" lights up and the screen shows a temperature
of 37°C. In this mode you can set a time between 1 and 8 minutes, which
you can do using the corresponding buttons. The word „Fast" will light
up 2 times, the appliance will make a sound and start heating. During he-
ating, the screen will show the remaining heating time and the displayed
temperature of 37°C is the target bottle temperature. Check the chart
provided with the product or SEE FIG.C to adjust the time according to
the amount of food to be heated. When the rapid heating is finished,
the machine will beep 5 times and will automatically switch on the 24
hour „Milk" mode, to maintain the temperature of the heated food, add
distilled water to the 160ml (MAX) line. If the appliance starts working
without water it will automatically switch off and can only be used again
once it has cooled down to room temperature, thus prolonging the life
of the appliance. Check the temperature of the warmed food before
feeding it to your baby.
b. Table description SEE FIG. C
B.1 Recommended time for rapid heating mode | B.2 Bottle material |
B.3 Plastic | B.4 Glass | B.5 Initial temperature | B.6 Food
NOTE: Actual time may vary due to bottle material, bottle wall thickness,
ambient temperature, initial food temperature, bottle temperature,
water temperature, amount of food.
Before feeding, make sure the food is at safe temperature to give to
your baby. If the food is not warm enough, place the bottle back in the
warmer for 0.5-1 minutes.
c. Heating/defrosting: insert the basket into the steriliser, pour in 160ml
of distilled water and then insert the feeding bottle and replace the lid.
Press the „Mode" button until „Milk" lights up and the screen shows the
previously set temperature between 35°C and 60°C and the default time
8