General Arrangement; Maintenance - MEDC BG3 Bedienungsanleitung

Operation
The unit is operated by the breaking of the glass. Due to the design of the unit, there is no need to use a
hammer as the operator is protected from the broken glass by the vinyl glass label.
Replacement of the glass
To replace the glass after operation of the unit, remove the small outer cover held in place by the single
M3 screw (2.5mm A/F hexagon key). Take out the glass and remove any broken fragments from the unit.
Place the new glass element into the unit and replace the cover. Following replacement of the glass it is
advised that the unit is tested using the procedure outlined above.

4.0 MAINTENANCE

During the working life of the unit, it should require little or no maintenance. GRP will resist attack by most
acids, alkalis and chemicals and is as resistant to concentrated acids and alkalis as most metal products.
However, if abnormal or unusual environmental conditions occur due to plant damage or accident etc.,
then visual inspection is recommended.
If the unit requires cleaning, then only clean exterior with a damp cloth to avoid electro-static charge build
up.
If a unit fault should occur, then the unit can be repaired by MEDC. All parts of the unit are replaceable.
If you acquired a significant quantity of units, then it is recommended that spares are also made available.
Please discuss your requirements with the Technical Sales Engineers at MEDC.
07/16

GENERAL ARRANGEMENT

© MEDC 2016