neotone NTK-50U Bedienungsanleitung Seite 15

Secure the camera with a clamping nut and make sure
that the sealant and the cable seal are not damaged
during assembly. Seal from the inside if necessary. Then
connect the plug of the camera to the signal / power
cable. Connect the signal cable to the device and the
power cable to the rear light of the vehicle (observe the
connection diagram).
Clamping nut
Camera
6. after all the installation work is completed, turn on your
device and make all the necessary settings. We wish you
a lot of fun!
Locking ring