E-SWIN E-Flash 4C Bedienungsanleitung Seite 60

Step 3: Flashing
1. Grab the device, making sure that your hand does not obstruct the air vents (found
under the device and its rear tip).
2. Press the mobile head of the device to the skin; making sure that its entire surface is
fully in contact with the skin.
3. Hold this position and trigger the flash by pressing simultaneously on the two buttons
found on either side of your device (right and left ,
Please refer to Chapter 3 of this manual to determine the power level intensity.
The more tanned of naturally pigmented the skin is, the more you must reduce the power
level to avoid any overheating or burning phenomenon.
If you do not see any flash of light and the red light turns on, it means that the skin is too dark
for safe application. Change the treatment area or check with the help service of the hair
removal device
Your device will charge immediately between each flash, the delay between
the onset of each flash is up to 2.9 seconds.
During this period, the first blue indicator light indicating the power level will turn on,
and then successively, the second will turn on and finally the third one will as well.
When the device is ready to flash, the blue indicator light(s), depending on the power
level you have chosen, will stay fixed.
60
(see details 3, " Skin colour detector").
and ).