Inserting The Batteries Into The Remote; Switching On The Tv - Toshiba 43 UF3D Serie Kurzanleitung

1

Inserting the Batteries into the Remote

Remove the back cover to reveal the battery compartment on the back side of the remote control first. Insert
two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct polarity).
Do not mix old and new batteries. Replace only with same or equivalent type. Place the cover back on.
To pair remote with the TV
When TV is turned on for the first time, a pairing process for your remote will be performed during the initial
setup. Your remote control should automatically pair with your TV at this point, but if it didn't, follow the on
screen instructions to pair it. If you experience difficulties pairing your remote with your TV you can turn off
other wireless devices and try again.
2
Connections
Antenna
Connect the antenna cable/s to your TV.
satellite
rear side of the TV
rear-left side of the TV
HDMI connection
rear side or rear-left
side of TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug one end (the two-hole plug) of the supplied detachable
power cord into the power cord inlet on the rear side of the TV. Then plug the other end
of the power cord into the mains socket outlet.
Plug the power cord to the mains socket whilst in 'off' position, and then turn the mains
socket on.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
3

Switching on the TV

In order to turn the TV on from standby mode:
• Press the Standby button on the remote control
• Press the control button on the TV
dish
aerial /
cable TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
Once you have connected external systems to your TV,
you can switch to different input sources. Press and
hold the Home button on your remote control to display
available quick settings menu options. Then highlight
the Inputs option and press the Select button to display
the list of available input options. Use the directional
buttons to highlight the option of your choice and then
press the Select button to switch to the selected input.
Or select the desired input from the Inputs row in the
inputs tab on the Home screen and press Select.
English - 1 -