Led Display - Oehlbach BTT 5000 Bedienungsanleitung

Erasing the memory:
Press the pairing button on the BTT 5000 for 5 seconds to reset
it and erase its memory. The LED will then flash briefly every 5
seconds. This may be necessary if you want to connect a new
device.

LED display

LED continuously flashes
red and blue
LED flashes blue (every 5
seconds)
LED does not illuminate
14
Status of the BTT 5000
Pairing mode
The BTT 5000 is in its pairing
mode and is searching for
devices
Power is not being supplied to the
BTT 5000