Inhaltsverzeichnis
Werbung
PROBLEM
Fails zu
Scheitholz
The log pusher
moves jerkily,
taking unfamiliar
noise or
vibrating
a lot
Oil leaks around
cylinder ram or
from other points
ACHTUNG ALLE REPARATURARBEITEN MÜSSEN VON EINEM
FACHMANN DURCHGEFÜHRT WERDEN.
65558UK00M110.indd
FEHLERBEHEBUNG
PROBABLE CAUSE
Log is improperly positioned
The sizes or hardness of the
log exceeds the capacity of the
machine
Wedge cutting edge is blunt
Oil leaks
Unauthorized adjustment was
made on Max. Pressure
Limiting Screw. Lower max
pressure rating was set.
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Air sealed in hydraulic
system while operating.
Bleed Screw is not tightened
before moving the log splitter.
Oil Drain Bolt with Dipstick is
not tight.
Hydraulic Control Valve
Assembly and / or seal(s)
worn
17
REMEDY SUGGESTED
Refer to "Log Splitter
Operation" section for
perfect log loading.
Reduce the log sizes before
splitting it on the log splitter.
Refer to "Sharpening Wedge"
section to sharpen the cutting
edge.
Locate leak(s) and contact
the dealer.
Contact the dealer.
Check oil level for possible
oil refilling.
Contact the dealer.
Loosen Bleed Screw by 3 ~ 4
rotations before operating the
log splitter.
Tighten the Bleed Screw up
before moving the log
splitter.
Tighten the Oil Drain Bolt
with Dipstick.
Contact the dealer
2018/8/24
Werbung
Inhaltsverzeichnis
