Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
leave the pool vacuum plugged in for long-term storage. Recharge the
pool vacuum every three months .
Above warnings and cautions are not intended to incorporate all possible
instances for risks and / or severe injuries. Pool / spa owners should always
exercise extra caution and common sense when utilizing the product.
GETTING STARTED
IMPORTANT NOTE: Fully charge the pool vacuum before it is used for the first time.
Charging The Battery
WARNING!
Charging must be done indoors, in a well-ventilated area away from sunlight,
children, heat, ignition sources, and with an ambient temperature between 5˚C (41˚F)
and 35˚C (95˚F).
Never use the external adaptor and charging base if any damage is detected.
Use only the original external adaptor provided.
Make sure the pool vacuum and the charger base are clean and dry before set-up.
1. Turn the locking knob (on each side) anticlockwise until it points to the green dot
marking (unlock position) to unlock and release the rear body from the transparent
case.
2. Place the rear body (upside down - power on/off button face up) on a flat surface.
Align and slide the hook of the charging base onto the side notch at the bottom of the
rear body until it stops. Make sure their contact plates are properly in contact. Plug
the female jack of the external adaptor into the charging port at the end of the
charging base.
WARNING!
DO NOT handle the pool vacuum, external adaptor and charging base while it is
charging with wet hands and without shoes.
8
Werbung
Inhaltsverzeichnis
