Set-Up Before Use; Handle Assembly; Suction Head Assembly; Telescopic Pole (Not Included) Assembly - Interline EV50 Bedienungsanleitung

time of the pool vacuum will gradually reduce through repeated charging and
discharging in operation.
NOTE: Let the pool vacuum rest for around 30 to 40 minutes before charging it again.

Set-Up Before Use

Handle assembly

Insert the handle into the pool vacuum as shown, until the side pin on the handle is
secured to the handle's locking hole on the rear body.
To release the handle, press down on the side pin and pull out the handle.

Suction head assembly

Insert the suction head directly into the suction mouth of the pool vacuum until. The
side tabs of transparent case will clip in the holes of the suction head's pivot.
NOTE: To replace the brushes on the suction head, lift the end and pull it out to make
space for a new one.
WARNING! For vinyl liner and fibreglass pools, it is recommended to keep the
brushes on the suction head to avoid damaging the pool.

Telescopic pole (not included) assembly

Insert the end (with one side pin) of the pole connector into the pool vacuum as
shown until its single side pin is secured to the handle's locking hole on the rear body.
Slide the telescopic pole into the pole connector until the side holes of the telescopic
pole are secured to the side pins of the pole connector.
10