Emptying The Filter - Interline EV50 Bedienungsanleitung

CAUTION! Make sure the pool vacuum is always facing downwards when it is placed
into the pool. Otherwise it may bend the pole connector and damage it during the
process.
2) To remove the pool vacuum from the pool / spa, lift the pool vacuum while pointing
it downwards in order to allow water to escape from the outlet valve. Water is going to
escape via the handle / pole connector and draining holes inside the handle chamber
on the rear body.
CAUTION! Make sure the pool vacuum is always facing downwards when it is
removed from the pool. Otherwise, the pole connector may be bent and damage the
pool vacuum in the process.
3) Rinse the pool vacuum with fresh water after every use. DO NOT use any
detergent.

EMPTYING THE FILTER

WARNING! Using the pool vacuum without a filter cone in place will VOID your
warranty.
In order to maximize the cleaning efficiency, be sure to clean the filter cone before
and after each use.
CAUTION! If the pool vacuum is charging, disconnect the external adaptor from the
power source and detach the pool vacuum from the charging base.
Emptying filter cone
1. Place the pool vacuum on a stable surface.
2. Turn the locking knob (on each side) anticlockwise until it is pointing towards the
green marking to unlock and release the transparent canister. Remove the
transparent canister from the rear body.
3. Tilt the transparent case and make sure the smaller end is pointing upwards, then pull
out the filter cone from the transparent case. Hold the filter cone horizontally and turn its
lid clockwise to detach it from the cone.
4. Rinse the transparent case and clean out the debris inside the filter cone. It is
recommended to clean the filter cone's net with splashing water. If brushing is deemed
12