Unclamping A Tool - Wte Standard Kurzanleitung

Figure 3: Clamping tool.
4.2

Unclamping a tool

Figure 4: Loosing clamping jaws
22
NOTE
Always tighten the pinion within the
specified tightening torque.
3. Turn the pinion clockwise to the stop with
the aid of the hex-wrench (see "Figure 3:
Clamping tool." Pos. 3).
4. Set the torque wrench to the tightening
torque stated in "Table 2: Technical data",
(page 18).
5. Tighten the pinion with the aid of the
torque wrench.
6. Check after the clamping process, if the
tool is clamped centrically. If not, repeat
steps 2 to 6.
Otherwise, see "Result".
RESULT
The tool is now fully clamped and the
drill chuck can be used.
1. Loosen the clamping jaws by turning the
pinion counterclockwise using the appro-
priate hex-wrench (see "Figure 4: Loosing
clamping jaws").
WTE NC Bohrfutter Standard/ NC Drill Chuck Standard
Kurzanleitung / Short manual