Battery Meter; Propeller Replacement - GreenWorks 9000107 Bedienungsanleitung

reverse speeds. The speed control may be operated in
either direction, forward or reverse.
■ Turn the tilt twist tiller handle (1) counterclockwise
from O (off) to increase reverse speed.
■ Turn the tilt twist tiller handle (1) clockwise from O (off)
to increase forward speed.
Thrust decreases as you approach O from either direction.
The numbers printed on the twist grip handle represent a
percentage of maximum thrust.
The twist grip tiller handle is shipped in the down position.
Firmly pull the handle up to the horizontal position. The
handle has five available positions: 45º down, horizontal,
15º, 30º and 45º tilted up. The handle locks in the
horizontal position, but can be tilted down by pushing the
release button (16) located on the left underside of the
handle pivot.
Never operate your motor when it is out of the water.
Battery
12 v Battery inForMation
note: Battery sold seperately.
The motors will operate with any deep cycle marine 12
V battery.
For best results it is recommended to use a deep cycle
marine battery with a minimum of 105 ampere hour rating.
As a general on the water estimate, your 12 V motor
will draw one ampere per hour for each pound of thrust
produced when the motor is running on high. The actual
ampere draw is subject to your particular environmental
conditions and operation requirements.
Always store battery at full charge when not in use. Battery
life will be extended by charging each time battery is used
and every two weeks when not in use. (Use a lamp timer
and charge each day for 1 hour even if battery is not use
as this will help maintain a full battery level.)
note: Only trickle charge your battery to full power, do
not speed/rapid charge the battery as this will shorten its
life.
If you are using a crank battery to start a gasoline outboard
it is strongly recommended to use a separate battery for
trolling motor to ensure of enough start up power for the
gasoline motor.

Battery Meter

See figure 7.
The LED provides an accurate display of the remaining
english (original instructions)
Caution
charge in the battery. The LED's only illuminate when the
motor in the ON position. The gauge reads as follows:
■ Four lights indicate full charge.
■ Three lights indicate good charge.
■ Two lights indicate low charge.
■ One light indicates recharge.
Battery ConneCtion
12 V Systems
■ Connect the positive (+) red lead to the positive (+)
battery terminal.
■ Connect the negative (-) blace lead to the negative (-)
battery terminal.
note: If installing a leadwire plug, observe proper polarity
and follow instructions in your boat owner's manual.
• Before connecting battery, make sure the tiller twist
handle is in the off position.
• Use only 6 gauge wire to extend power lead.
• Improper wiring of 12 V system could cause battery
explosion!
• Keep leadwire wing nut connection tight and solid to
the battery terminals.
• Locate battery in a ventilated compartment.
This is supplied as a quick reference guide however
battery types, brands and sizes may vary in performance
and abilities. Always read your battery manufacturers
manual for specific battery requirements or contact the
manufacturer for best practices and/or advice.

ProPeller rePlaCeMent

ProPeller rePlaCeMent
See figure 8.
■ Hold the propeller (10) and loosen the prop nut (12)
with a pliers or a wrench.
■ Remove prop nut (12) and washer (13).
note: If the drive pin is sheared/broken, you will need to
hold the shaft steady with a screwdriver blade pressed into
the slot on the end of the shaft.
■ Turn the old prop to horizontal (as illustrated) and pull
it straight off. If the drive pin falls out, push it back in.
■ Align new propeller with drive pin.
8
warning
iMPortant