Werbung
Quicklinks
Without load
With load, aging and temperature at 3.6 V
without delay compensation
General Information
> 100 mm
Shield on housing
Zero position for shaft/cap alignment
18
Ø 4.5 mm
R 1 ‡
mm
Rising code values
> 100 mm
> 200 mm
Noise sources
Mounting kit included
Spacer
Note: Mounting and commissioning is to be conducted by a specialist in electrical
equipment and precision mechanics under compliance with local safety regulations.
Do not engage or disengage any connections while under power.
The drive must not be put into operation during installation.
{
Mounting Instructions
Werbung
Verwandte Anleitungen für HEIDENHAIN EQN 1325.048
Inhaltszusammenfassung für HEIDENHAIN EQN 1325.048
- Seite 1 Rising code values Without load With load, aging and temperature at 3.6 V Mounting Instructions Mounting kit included Spacer without delay compensation General Information Note: Mounting and commissioning is to be conducted by a specialist in electrical equipment and precision mechanics under compliance with local safety regulations. >...
- Seite 2 Assembly Electrical connection Press cable into place À Á Â Two ways of pressing the encoder out during dismounting Required mating dimensions À ¬ Bearings for customer shaft Attachment for cable with crimp sleeve ¬ 6+0.3 x10 Á Bearings for encoder Plug connector, 16-pin Â...