Charging The Rechargeable Battery; Using The Appliance - Clatronic HSM/R 3313 Bedienungsanleitung

Charging the Rechargeable Battery

1. Switch off the appliance:
Slide the switch (4) down. OFF is visible on the switch.
2. Connect the power supply plug with one of the connec-
tion sockets listed below.
• There is a connection socket directly at the lower end
of the appliance.
• Or place the appliance in the charging / installation
station. The connection socket is located at the rear.
3. Connect the power supply unit to a socket.
- The charging indicator lights up during the charging
process.
- The charging indicator light gives no indication of the
rechargeable battery's charge status.
- Mains-only operation is not possible.
4. Charge the appliance for 14 hours before using it for the
first time.
- Always unplug the power supply unit after 14 hours
of charging.
You will extend the life of the rechargeable battery if
you observe the following:
• Wait until the rechargeable battery is almost empty
before charging.
WARNING:
• Switch off the appliance before cleaning. Unplug the power sup-
ply unit from the socket.
• Do not immerse the appliance, the charging station or the power
supply unit in water!
CAUTION:
• Also do not clean the appliance under running water!
The electronics could be damaged.
• Do not use a wire brush or other abrasive objects.
• Do not use any sharp or abrasive cleaning agents.
• Regular cleaning and maintenance guarantee optimum
results and a long service life.
• Remove hair residues after each use with the cleaning
brush.
1. To do this, pull off the cutting length comb (1).
2. To fold out the shaving head, press the two buttons
(2) on the back of the appliance.
3. After cleaning, fold the shaving head back in so that
you hear it click into place.
4. Place the cutting length comb back on.
HSMR3313_IM_09.2022
• Do not leave the appliance connected to the charger for
more than 14 hours.
• Only charge the appliance at an ambient temperature
between 0 °C and + 40 °C.

Using the Appliance

Switching On and Off
Slide the switch (4) to turn the appliance on or off.
Cutting Hair and Trimming the Beard
1. Select the cutting length with the help of the cutting
length comb. Press and slide the button (3) at the same
time.
2. Slide the switch (4) towards the shaving head.
Trimming Contours and Shaving Out the Neck
• Remove the cut length comb (1) and slide the switch (4)
towards the shaving head.
• The shaving head enables precise trimming of the beard
contours and clean shaving of the hairline at the nape
of the neck.
End Operation
Slide the switch (4) down.
Cleaning
• Clean the outside of the appliance if necessary with a
slightly damp cloth.
• Clean the power supply unit only with a dry cloth.
Important Care Advice
To maintain the cutting performance of the shaving head
for a long time, regularly apply 1 – 2 drops of acid-free / res-
in-free oil, such as shaving head oil, sewing machine oil or
precision mechanics oil to the shaving head. This lubrication
keeps the shaving head running smoothly and prevents the
blades from becoming blunt.
9
04.10.22