ECOPOSTURAL C3566 Bedienungsanleitung Seite 9

English
Absolutely avoid leaning on the very edge for support as it may tilt over.
If pressure on a reduced area exceeds the allowed weight, the table upholstery could split up. Keep the
patients from getting on by their knees.
To get on the couch the patient must seat at the middle section. Then he can lean back.
When getting down the couch different procedures apply depending on the position of the patient.
Therefore, if he is lying down (prone position) he has to slide gently towards the middle of the couch, lean
on his side and lean forward by standing on his arms. He will then be able to put his legs out by the table's
side and easily stand up.
If the patient is lying upwards, raise the backrest and lower the leg section so that he gets back to a seated
position enabling him to go down the couch.
In case the Chair is equipped with armrests: flip them up to get up / down the Chair easily.
* Caution! The patient must not lean on the armrest as it could split.
The patient's WEIGHT must necessarily be CONCENTRATED AT THE MIDDLE SECTION.
NEVER USE THE BACK OR FEET SECTIONS TO LEAN FORWARD as the couch is not
aimed at such a use and could unbalance.
c) HEIGHT adjustment
The central height of the table is operated by an electric motor.
To operate the supply cable must be plugged into a 220-230 V socket.
SAFELY POSITION PATIENT BEFORE TABLE HEIGHT ADJUSTMENT.
Do not insert hands, feet or garments into the moving parts of the elevating mechanism as
this could result in serious injuries.
For adjusting the height use the foot pedal. Press the foot control switch pedal: left downwards / right
upwards.
d) SECTIONS adjustment
The head-/backrest section is operated by a gas spring (3)
The central section is operated by a gas spring (3)
The feet section is operated by knob/lever (1)
The feet section being detachable simply pull out the pull tabs at both sides of the section to release the
fastener. Then pull out the section completely. Next, release the leather strips by detaching the Velcro
under the seat.
In order to place the feet section back on proceed in the reverse order. Pull out the pull tabs and slide the
fasteners through the holes at both sides of the section. Next release the fasteners to lock. Finally join
together the leather strips under the seat.
(1) Knob/Lever: With one hand, loosen the knob or lever to release the bar. With the other hand, position
the section at the required tilting. Release the knob or lever and the section will lock itself.
(3) Gas spring: Press the mechanism situated at the very edge of the section towards the upholstery and
the table section will go up slowly. Release mechanism to lock position. To lower the section, press the
mechanism with one hand and with the other hand, push the section downwards to the required position.
9