Before Use - Grouw! 18235 Gebrauchsanweisung

BEFORE USE

The package should contain the fol-
lowing:
Package contents:
• 12 V MAX battery-powered pruning
saw
• Quick battery charger
• Saw support
• Blade for wood 150 mm
• Case
• User manual
Open the packaging and carefully take
the saw out. Check that the set is com-
plete and intact.
Fully charge the battery before the first
use.
Connect the battery (3) with the charger
(12).
Connect the charger (12) to the power
outlet if the battery is not charged, the
red LED (14) will light up to indicate that
the battery is charging.
When charged, the red LED (14) will
turn off. the green LED (13) will light up
instead to indicate that the battery is
charged (after approx. 73 min). Unplug
the charger and disconnect the battery
from the charger.
USE
Battery installation
Slide the battery (3) into the socket, and
check whether it is correctly locked in
the handle.
To take the battery out again, press and
hold the battery lock button (4), and pull
out the battery.
Blade mounting/Un-mounting
Wear protective gloves when installing/
changing the blade. The blade teeth
should always point down.
Turn the blade clamp (8) counterclock-
wise and hold it in this position.
Insert the blade (6), push it as far as it
goes, and release the clamp (8).
Verify whether the blade (6) has been
installed correctly: gently grab its top
on the blunt part to check whether it is
appropriately fixed.
6
To remove the blade (6), turn the blade
clamp (8) counterclockwise and hold it
in this position. Then pull out the blade
to remove it.
6
Saw support installation/uninstalla-
tion
Press the unlock button (10), then slide
the saw support (11) on the base guides
into the saw.
Release the unlock button (10).
47
8
8
10
GB