Logitech Trueforce G923 Bedienungsanleitung Seite 11

2
Press the button you want to set as the dual clutch button.
The only valid buttons for this are the L3 and R3 buttons.
The RPM LEDs will flash red to show that you're in clutch
position setting mode.
3 While in your chosen simulation or game with the car still on
a track, fully depress the clutch and gas pedals. Engage first
gear and keep pressing the minus button down until the car
begins to move in-game. You can adjust the precise bite point
of the clutch by using the plus and minus buttons until you
are happy with the setting.
4
At this point, you may test the dual clutch without
leaving the setting mode. It is recommended you attempt
a race start, stop the car and adjust the bite point and
then try again until you are satisfied with the performance
of the dual clutch.
5
Press the Select button in the middle of the dial on the wheel
to exit dual clutch setting mode. The RPM LEDs will flash
in a sequence from green to blue to show that the setting is
saved. The RPM LEDs will then go out and begin responding
again to RPM output from supported games.
11 ENGLISH