Parts Description; Preparation Before Use; How To Use - Makita UT001G Betriebsanleitung

PARTS DESCRIPTION

Model UT001G
► Fig.1
1 Switch trigger
3 Lock button
5 Speed change knob
7 Handle
9 Shaft
Model UT002G
► Fig.2
1 Switch trigger
3 Lock button
5 Speed change knob
7 Handle
PREPARATION
BEFORE USE
Indicating the remaining battery capacity
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
► Fig.3: 1. Indicator lamps 2. Check button
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
2 Lock-off button
4 Speed adjusting dial
6 Battery cover
8 Shaft holder
10 Mixing blade
2 Lock-off button
4 Speed adjusting dial
6 Battery cover
8 Chuck
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Things you need to know before use
Hold the handle when using or carrying the tool.
► Fig.4
CAUTION:
Do not hold the sheet metal part.
Sharp areas may cause injury.
Tool / battery protection system
The tool is equipped with a tool/battery protection sys-
tem. This system automatically cuts off power to the
motor to extend tool and battery life. The tool will auto-
matically stop during operation if the tool or battery is
placed under one of the following conditions:
Overload protection
When the tool/battery is operated in a manner that
causes it to draw an abnormally high current, the tool
automatically stops. In this situation, turn the tool off
and stop the application that caused the tool to become
overloaded. Then turn the tool on to restart.
Overheat protection
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the tool/battery cool
before turning the tool on again.
Overdischarge protection
When the battery capacity becomes low, the tool stops
automatically. If the product does not operate even
when the switches are operated, remove the batteries
from the tool and charge the batteries.

HOW TO USE

CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
NOTICE:
When you are not working, lay the
machine down and store it.
► Fig.5
Assembly
Installing the shaft
Optional accessory
For UT001G
1. Tighten the shaft into the shaft holder.
► Fig.6: 1. Shaft 2. Shaft holder
2. Hold the flats on the shaft holder with wrench 19
so that the shaft holder cannot revolve. With the flats
held so, tighten the hex nut with another wrench 19 in
the direction of arrow.
► Fig.7: 1. Shaft 2. Shaft holder
9 ENGLISH