Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting Menu on LCD Screen
2). When "load mode" is displayed, long press
setting. Press
or else, the system will not save the setting that was just made and automatically
exits the setting after 12s.
Select flooded lead-acid battery
System voltage setting
Battery Types, Charging Voltages (Lithium Battery), Over-Discharge Return
ant' Over-Discharge Voltage Settings
In the non-load mode menu:
1) When
is long pressed, the first interface entered is for battery type setting,
and the flashing one is the battery type currently selected. Press
FLD/GEL/SLD/LI.
2) After selection, short press
charge voltage settings; or the first to enter charging voltage setting menu for lithium
battery.
3) After parameters have been set, long press
Parameters shall be set according to the following rule: over-discharge voltage
adjacent values shall have a difference greater than 0.5 V.
to adjust the mode, and long press
Select sealed lead acid battery
Select GEL Battery
Battery type selection
Over-discharge voltage setting
to enter into over-discharge return and over-dis-
to enter into the load mode
Select lothiun battery Lithium charging point voltage setting
for 2 s to save and exit.
- 6 -
for 2s to save and exit;
Over-discharge return voltage setting
to select among
Werbung
Inhaltsverzeichnis
