Makita DUB187 Betriebsanleitung Seite 7

It is an employer's responsibility to enforce
the use of appropriate safety protective equip-
ments by the tool operators and by other per-
sons in the immediate working area.
4. To prevent dust irritation the wearing of a face
mask is recommended.
While operating the machine, always wear non-
5.
slip and protective footwear. Non-skid, closed-toed
safety boots and shoes will reduce the risk of injury.
Use personal protective equipment. Always
6.
wear eye protection. Protective equipment such
as a dust mask, non-skid safety shoes, hard hat or
hearing protection used for appropriate conditions
will reduce personal injuries.
Operation
1. Switch off the machine and remove the battery
cartridge and make sure that all moving parts
have come to a complete stop
• whenever you leave the machine.
before clearing blockages.
•
• before checking, cleaning or working on
the machine.
• if the machine starts to vibrate abnormally.
whenever you convert the machine from
•
blower to vacuum, and vice versa.
after striking a foreign object to inspect
•
the machine for damage.
2. Operate the machine only in daylight or in
good artificial light.
3. Do not overreach and keep proper balance and
footing at all times.
4. Always be sure of your footing on slopes.
Walk, never run.
5.
6. Keep all cooling air inlets clear of debris.
7. When using the machine for blower operation,
never blow debris in the direction of bystand-
ers. When using the machine for vacuuming
operation, be careful not to blow debris in the
direction of bystanders with the exhausted
wind from the dust bag.
8. Operate the machine in a recommended posi-
tion and on a firm surface.
9. Do not operate the machine at high places.
10. Never point the nozzle at anyone in the vicinity
when using the machine.
11. Never block suction inlet and/or blower outlet.
• Be careful not to block suction inlet or
blower outlet with dust or dirt when oper-
ating in dusty area.
• Do not use nozzles other than the nozzles
provided by Makita.
• Do not use the blower to inflate balls,
rubber boat or the similar.
12. Do not operate the machine near open window, etc.
13. Operating the machine only at reasonable hours
is recommended - not early in the morning or
late at night when people might be disturbed.
14. Using rakes and brooms to loosen debris
before blowing is recommended.
15. If the machine strikes any foreign objects or
should start making any unusual noise or
vibration, immediately switch off the machine
to stop it. Remove the battery cartridge from
the machine and inspect the machine for
damage before restarting and operating the
machine. If the machine is damaged, ask
Makita Authorized Service Centers for repair.
16. Do not insert fingers or other objects into
suction inlet or blower outlet.
17. Prevent unintentional starting. Ensure the
switch is in the off-position before inserting
battery cartridge, picking up or carrying the
machine. Carrying the machine with your fin-
ger on the switch or energizing the machine
that has the switch on invites accidents.
18. Never blow or vacuum dangerous materials,
such as nails, fragments of glass, or blades.
19. Do not operate the machine near flammable
materials.
20. Avoid operating the machine for a long time in
low temperature environment.
21. Never operate the machine with defective
guards or shields, or without safety devices.
Maintenance and storage
Keep all nuts, bolts and screws tight to be sure
1.
the machine is in safe working condition.
2. If the parts are worn or damaged, replace them
with parts provided by Makita.
3. Store the machine in a dry place out of the
reach of children.
4. When you stop the machine for inspection,
servicing, storage, or changing accessory,
switch off the machine and make sure that
all moving parts come to a complete stop,
and remove the battery cartridge. Cool down
the machine before making any work on the
machine. Maintain the machine with care and
keep it clean.
Failure to do so may cause accident or injury.
5. Always cool down the machine before storing.
6. Do not expose the machine to rain. Store the
machine indoors.
7. When you lift the machine, be sure to bend your
knees and be careful not to hurt your back.
8. Perform the maintenance regularly. It is rec-
ommended to perform the maintenance before
each operation.
Battery tool use and care
1. Recharge only with the charger specified by
the manufacturer. A charger that is suitable for
one type of battery cartridge may create a risk of
fire when used with another battery cartridge.
7 ENGLISH